Hydrotech Precision-PWS 12-12 OWNERS GUIDE - Manual (Page 25)

25
1. Remove any protective plastic coating (white, blue or clear plastic) from
the lid.
Boiling Tank Lid Operation Diagram
2. Refer to the Boiling Tank Lid Operation Diagram above. Take the
boiling tank lid in your hand. Hold the Tee Bar bracket and turn the Lid
Knob counter-clockwise so that there is ½” of space between the Tee Bar
bracket and the lid.
3. Tip the lid so that the Tee Bar bracket slips under the rim of the boiling
tank opening on one side, and then slide the lid so the Tee Bar bracket
slips under the other side of the rim. Center the lid.
4. Turn clockwise to tighten the lid onto the boiling tank. The water level pin
inside the boiling tank will prevent the lid from turning while tightening.
Practise removing and replacing the lid a few times as the lid will need to
be removed each time the water distiller is cleaned.
1. To remove the storage tank lid, turn the Lid Knob counter-clockwise while
lifting. Lifting while turning holds the Tee Bar bracket under the lid and
allows you to loosen the lid. Continue turning and lifting until there is ½” of
space between the Tee Bar bracket and the lid.
2. Tip the lid so that the Tee Bar bracket slips out from under the rim of the
storage tank opening on one side, and then slide the lid so the Tee Bar
bracket slips out from under the other side of the rim.
Boiling Tank Lid Installation
Storage Tank Lid Removal and Installation