Hydrotech PURA QCRO Series Quick Change Reverse Osmosis Drinking Water System - Manual (Page 26)

24
1. Turn off incoming water supply
to RO.
2. Open RO Faucet and allow water
to drain from the tank until it is
completely empty.
3. Check that air pressure is between
5-7 psi using an air pressure gauge.
4. If the pressure is low use a bicycle
pump to increase pressure to 5-7 psi.
5. Follow startup procedure.
1. Turn off incoming water supply
to RO.
2. Open RO Faucet and allow water
to drain from the tank until it is
completely empty.
3. Check that air pressure is between
5-7 psi using an air pressure gauge.
4. If the pressure is low use a bicycle
pump to increase pressure to 5-7 psi.
5. Follow startup procedure.
Metal Tank Sanitization Procedure
Plastic Tank Sanitization Procedure
1. Turn off water supply to your RO
system by turning off the adapter
valve. Open the faucet to drain the
storage tank.
2. Once the tank has emptied. Discon-
nect the tube from the ball valve on
the storage tank.
1. Turn off water supply to your RO
system by turning off the adapter
valve. Open the faucet to drain the
storage tank.
2. Once the tank has emptied. Discon-
nect the tube from the ball valve on
the storage tank.
3. Using a clean eye dropper insert 1/2
teaspoon of hydrogen peroxide or
common household bleach into the
tube.
4. Reconnect the tube to the ball
valve. Follow the start up procedure
and drain the first two full tanks of
water.
3. Using a clean eye dropper insert 1/2
teaspoon of hydrogen peroxide or
common household bleach into the
tube.
4. Reconnect the tube to the ball
valve. Follow the start up procedure
and drain the first two full tanks of
water.
tank Pressure Check
tank Pressure Check