Hydrotech PURA QCRO Series Quick Change Reverse Osmosis Drinking Water System - Manual (Page 17)

15
Faucet
Base
(Remove white protective film)
Plastic Washer
Large Rubber Washer
Small Rubber Washer
Nut
Faucet Adapter
Lock Washer
 1
 3
 5
 6
 7
 8
 2

4
Standard Faucet installation
1. Remove white protective film from faucet base. Install faucet body, small rubber washer, metal base, and large rubber
washer above sink (items 1-4).
2. Install plastic washer, lock washer and nut (items 5-7) onto faucet stem below sink and tighten. Be sure to properly align
the faucet.
3. Install the faucet adapter (item 8). Connect the 3/8" blue tubing to the faucet adapter.
Note: If installing a standard faucet the red 1/4” drain line will be installed directly to the drain. Disregard the
instructions on the following page.
Non Air Gap Faucet (Optional)
Drinking Water Line to Faucet
(3/8” Blue Tubing)