Alto-Shaam AR-7E - Manual (Page 16)

O P E R AT I N G I N S T R U C T I O N S
A R - 7 E R o t i s s e r i e O p e r a t i o n & C a r e M a n u a l • 1 4
The Alto-Shaam rotisserie provides the operator with the ability to set as many as seven cooking programs.
Each cooking program can be preset to include all cooking and holding functions. Cooking programs are
stored and recalled using the P
RESET
Keys labeled 1 through 7.
PROGRAMMING A COOKING PROGRAM:
With the rotisserie oven in the “
OFF
” position, determine the food product procedure to be
programmed. Press and release control
ON
/
OFF
key. The oven will beep for one second and power to
the unit will be indicated by an illuminated green indicator light located in the upper left corner of
the O
N
/O
FF
key. The oven will begin operating in the hold mode. The amber hold indicator will be
illuminated and the last set hold temperature will be displayed.
Select a number for the programmed product. Press and hold the selected P
RESET
number key
until you hear an audible signal which will occur within 3 seconds. The number key program
indicator light will illuminate. The programmed product is now stored in memory on the
specific number key selected.
TO COOK WITH PRESET MENU KEYS:
PRESS AND RELEASE CONTROL
ON
/
OFF
KEY.
• The control will beep and the green indicator light on the
ON
/
OFF
key will illuminate.
• The amber hold indicator will illuminate.
• The oven will begin operating in the hold mode.
• The previously set hold temperature will be displayed.
• The green indicator will illuminate on all programmed
PRESET
Keys.
PRESS DESIRED PRESET KEY (1
THROUGH
7)
• The Pre-Heat indicator will illuminate.
➥
The rotisserie oven will automatically preheat to the cooking temperature programmed.
• The oven will beep when preheated and the preheat indicator will go out.
• Both the Ready and Start indicator lights will flash.
➥
The set cook temperature will be maintained by the oven and appear in the display
while in the ready/start mode.
NOTE: Presets cannot be modified once selected. If a modification is desired, the preset must be
erased and re-saved.
LOAD THE PREPARED PRODUCT SPITS INSIDE OVEN AND CLOSE THE OVEN DOOR.
PRESS AND RELEASE THE START KEY.
NOTE: The rotisserie will beep 4 times when cooking is finished.
P R E S E T M E N U K E Y O P T I O N
NOTE: The last PRESET Key programmed will be the oven cooking run sequence for the next product
to be programmed. Settings can be manually changed for the next product and an alternate
pre-programmed letter key selected.
ENTER ALL COOKING AND HOLDING PARAMETERS FOR THE
PRODUCT SELECTED AS INSTRUCTED ON THE PREVIOUS PAGE.