American Dryer Corp. ML-75DIII - Manual (Page 59)

55
2. Water Connections:
The water connection is made to the 1/2" M.P.T. bushing of
the electric water solenoid valve located at the rear upper
left area of the dryer (see photo). The water solenoid valve
has a 3/8" M.P.T. connection and a 1/2" bushing is supplied
to provide the minimum 1/2-inch supply (feed) line. Flexible
supply line/coupling must be used in effort to avoid damage
to electric water solenoid valve.
IMPORTANT: Flexible supply line/coupling must be used. Solenoid valve failure due to hard
plumbing connections WILL VOID WARRANTY. It is recommended that a filter
or strainer be installed in the water supply line.
Typical water supply ...