Uw models with b-control, Warning – Alliance Laundry Systems Extractors P232156R9 User Manual

Page 43

Basic Installation/Operation

F232156

UW Models with B-Control

1. When display shows “----,” washer-extractor is

ready to be loaded with laundry.

2. Use left hand to press and hold the door unlock

button located on the lower right front of the
control panel. Refer to Figure 28.

Figure 28

3. Use right hand to turn door handle clockwise and

swing the door left to open. Refer to Figure 29.

Figure 29

4. Load the washer-extractor to full capacity

whenever possible, but do not exceed the rated
dry-weight capacity of the machine if the fabric
to be washed is quite dense, closely woven, and
heavily soiled.

Overloading can result in an inferior wash. The
operator may need to experiment to determine
load size based on fabric content, soil content,
and level of cleanliness required. Do not
underload the machine. Underloading can result
in premature bearing and sealing failure and out-
of-balance situations.

Figure 30

PHM601N

PHM593N

WASH

ADD

BLEACH

RINSE

SPIN

DOOR

NORMAL

LIGHT SOIL

UNIFORMS

HEAVY SOIL

STAINED

DELICATE

HOT

WARM

COLD

START

PERM PRESS

VISA

PHM590N

WARNING

MACHINE MAY BE HOT

AND CAUSE BURNS

ATTEMPT NO ENTRY UNTIL

BASKET HAS STOPPED

SERIOUS INJURY MAY RESULT

Do not operate machine in a cycle with
program keymode switch in program
position. Program keymode switch must
be in run position at all times, except
when editing or programming cycle or
setup information.

W528

WARNING

Do not operate machine in a cycle or if
spinning with program keymode switch in
program position.

W529

WARNING