APW Wyott CMW-24 - Manual (Page 4)

4
!
WARNING: This symbol refers to a potential hazard or unsafe practice, which could result in
serious injury or death.
!
! !
DANGER: This symbol warns of imminent hazard which will result in serious injury or death.
! !
CAUTION: This symbol refers to a potential hazard or unsafe practice, which may result in minor or
moderate injury or product or property damage.
! !
NOTICE: This symbol refers to information that needs special attention or must be fully understood
even though not dangerous.
SAFETY PRECAUTIONS
Before installing and operating this equipment be sure everyone involved in its operation are fully trained
and are aware of all precautions.Accidents and problems can result by a failure to follow fundamental rules
and precautions.
The following words and symbols, found in this manual, alert you to hazards to the operator, service
personnel or the equipment. The words are defined as follows:
SPECIFICATIONS
(All 208 or 240 Volts, 50-60 Hz, Single Phase)
Model Model
Input Power
Requirement
Input Power
Requirement
Heating
Elements
Heating
Elements
Electrical Electrical
CMC-24 (Counter Top) 2.4kw 2 @ 1200W
CMW-24 (Wall Mount) 2.4kw 2 @ 1200W
CMP-24 (Pass Thru) 2.4kw 2 @ 1200W
CMC-36 (Counter Top) 3.6kw 2 @ 1800W
CMW-36 (Wall Mount) 3.6kw 2 @ 1800W
CMP-36 (Pass Thru) 3.6kw 2 @ 1800W
CMC-48 (Counter Top) 4.2kw 2 @ 1050W
CMW-48 (Wall Mount) 4.2kw 2 @ 1050W
CMP-48 (Pass Thru) 4.2kw 2 @ 1050W
CMC-48C (Counter Top) 3.4kw 2 @ 850W
CMW-48C (Wall Mount) 3.4kw 2 @ 850W
CMP-48C (Pass Thru) 3.4kw 2 @ 850W
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
All containers should be examined for damage before and during unloading. The freight carrier has
assumed responsibility for its safe transit and delivery. If equipment is received damaged, either apparent
or concealed, a claim must be made with the delivering carrier.
A. Apparent damage or loss must be noted on the freight bill at the time of delivery. It must then
be signed by the carrier representative (Driver). If this is not done, the carrier may refuse the
claim. The carrier can supply the necessary forms.
B. For concealed damage or loss, if not apparent until after equipment is uncrated, a request
for inspection must be made to the carrier within 15 days The carrier should arrange an
inspection. Be certain to hold all contents and packaging material.
Installation and start up should be performed by a qualified installer who thoroughly read, understands and
follows these instructions.
If you have any questions concerning the installation, operation, maintenance or service of this product,
write Technical Service Department APW Wyott Foodservice Equipment Company, P.O. Box 1829,
Cheyenne, WY 82003.