Hellwig Air 6290 - Manual (Page 20)

559-734-7451 800-367-5480 FAX 559-734-7460
Connect to inlet
of leveling valve.
Tighten this part
of fitting only to
avoid damaging
check valve
Braided hose
from compressor.
26. Connect compressor hose to tank fitting as shown above. Take care to tighten only the
specified fitting to avoid damaging check valve. Connect 3/8” tube elbow to inlet of leveling
valve with 3/8” nylon hose supplied. Route tubing to avoid chafing or damaging tubing.
27. Connect air springs to leveling valve as shown. Loop passenger side hose over crossmem-
ber as shown to avoid contact with exhaust pipe. Tie strap hoses as required to avoid contact
with exhaust and chafing on frame. (picture shown is for hose routing information only as ve-
hicle shown has 6” lift installed.)