Hellwig Air 6102 - Manual (Page 5)

559-734-7451 800-367-5480 FAX 559-734-7460
HOSE NUT STYLE FITTING
HOSE PORT CONNECTION AIR LINE FARREL AIR LINE HOSE END NUT
W/O TUBE INSERT CONNECTED
HOSE TUBE INSERT
( USE IF NOT ATTACHED TO HOSE PORT ) FERRAL
HOSE PORT CONNECTION
AIR LINE HOSE END NUT PLASTIC FERRAL
( W/TUBE INSERT CONNECTED )
INSERT TUBE INTO AIR HOSE END IF NEEDED. BE SURE AIR HOSE IS CUT STRAIGHT AND CLEAN. RESHAPE AIR HOSE TO BE AS
ROUND AS POSSIBLE, PLACE HOSE END NUT OVER HOSE, PUSH HOSE INTO HOSE PORT COMPLETELY. TIGHTEN TO BE SNUG,
DO NOT OVER TIGHTEN OR DAMAGE TO THE CONNECTION MAY OCCUR.
BELLOWS QUICK DISCONNECT STYLE AIR FITTING
AIR LINE COLLET AIR FITING
TO INSTALL AIR LINE, PRESS AIR LINE INTO THE COLLET ON THE AIR LINE FITTING UNTIL THE AIR LINE BOTTOMS IN
THE FITTING THIS WILL LOCK THE AIR LINE INTO PLACE. TO REMOVE, PUSH THE COLLET IN, HOLD AND PULL ON THE
AIR LINE THIS WILL RELEASE THE AIR LINE
NOTE: MAKE SURE AIR LINE IS CUT STRAIGHT AND IS AS ROUND AS POSSIBLE TO MAKE A GOOD SEAL OR LEAKING
MAY OCCUR
SCHRADER AIR FILL VALVE
AIR LINE COLLET INNER SLEEVE MOUNTING NUT DUST CAP
TO INSTALL AIR LINE ONTO THE SCHRADER VALVE FOLLOW INSTRUCTIONS AS STATED ABOVE BE CAREFUL NOT TO
DAMAGE THE AIR LINE INNER SLEEVE.
NOTE: SOME AIR LINE FITTINGS MAY OR MAY NOT HAVE THE INNER SLEEVE
NOTE: MAKE SURE AIR LINE IS CUT STRAIGHT AND IS AS ROUND AS POSSIBLE TO MAKE A GOOD
SEAL OR LEAKING MAY OCCUR.
SCHRADER VALVE W/BARB END FITTING
AIR LINE COLLET INNER SLEEVE MOUNTING NUT DUST CAP
W/BARB FITTING
HOSE END NUT
R-11 4/17/07