Hellwig Air 6102 - Manual (Page 3)

IMPORTANT NOTE
DO NOT ATTEMPT ANY MODIFICATIONS TO THE VEHICLE OTHER THAN
THOSE OUTLINED IN THIS INSTRUCTION SHEET. IF ANY INTERFERENCE
OCCURS WITH GAS TANKS , BRAKE & FUEL LINES , EXHAUST PIPES , ETC.,
STOP YOUR INSTALLATION AND CONTACT HELLWIG PRODUCTS CO. FOR
TECHNICAL ASSISTENCE OR INSTRUCTIONS.
NEVER LOAD THE VEHICLE THIS UNIT IS BEING INSTALLED ON BEYOND
THE MANUFACTURERS MAXIMUM GROSS VEHICLE WEIGHT RATING.
WHEN LIFTING THE VEHICLE WITH A JACK, BE SURE TO SET THE PARKING
BRAKE AND BLOCK THE TIRES. USE SAFETY STANDS AND SUPPORT THE
VEHICLE BY THE AXLE TO KEEP THE SUSPENSION LOADED.
WHEN REINSTALLING THE TIRES ON THE VEHICLE , CHECK THE
MANUFACTURERS SPECIFICATIONS FOR PROPER TORQUE RATINGS.
MOVE ANY ELECTRICAL WIRES , FUEL & BRAKE LINES , OR ANY OTHER
OBJECTS INSIDE THE FRAME RAILS BEFORE DRILLING ANY HOLES TO
AVOID DAMAGE TO ANY OF THE VEHICLES COMPONENTS.
BE SURE THE FLAT PLATES INSIDE THE FRAME RAILS ARE BEHIND ANY
WIRES , LINES , OR HOSES TO AVOID PINCHING OR CRUSHING WHEN THE
MOUNTING HARDWARE IS TORQUED TO THE SPECIFIED RATE.
THIS UNIT MUST BE MOUNTED SECURELY TO THE VEHICLE AT THE TOP AND
BOTTOM MOUNTING BRACKETS PRIOR TO ADDING ANY AIR PRESSURE OR
DAMAGE CAN OCCUR.
THE PROPER AIR SPRING SETUP HEIGHT IS BETWEEN FIVE ( 5 ) AND SIX AND
ONE HALF ( 6-1/2 ) INCHES. BETWEEN THE TOP OF AIR SPRING END CAP TO
BOTTOM OF AIR SPRING END CAP.
559-734-7451 800-367-5480 FAX 559-734-7460
6102 ( R-6102 ) 09-17-07