Brooks Instrument MT3810 - Manual (Page 27)

2-1
Installation and Operation Manual
X-VA-MT3810-eng
Part Number: 541B050AHG
June, 2008
Model MT 3810
Section 2 Installation
2-1 General
This section contains the procedures for the receipt and installation of the
instrument. See Section 1 for dimensional and connection requirements.
Do not attempt to start the system until the instrument has been perma-
nently installed. It is important that the start-up procedures be followed in
the exact sequence presented.
2-2 Receipt of Equipment
When the instrument is received, the outside packing case should be
checked for damage incurred during shipment. If the packing case is
damaged, the local carrier should be notified at once regarding his liability.
A report should be submitted to your nearest Product Service Department.
Brooks Instrument
407 W. Vine Street
P.O. Box 903
Hatfield, PA 19440 USA
Toll Free (888) 554-FLOW (3569)
Tel (215) 362-3700
Fax (215) 362-3745
E-mail: [email protected]
www.BrooksInstrument.com
Brooks Instrument Brooks Instrument
Neonstraat 3 1-4-4 Kitasuna Koto-Ku
6718 WX Ede, Netherlands Tokyo, 136-0073 Japan
P.O. Box 428 Tel 011-81-3-5633-7100
6710 BK Ede, Netherlands Fax 011-81-3-5633-7101
Tel 31-318-549-300 Email: [email protected]
Fax 31-318-549-309
E-mail: [email protected]
Remove the envelope containing the packing list. Outside of your clean area,
carefully remove the equipment from the packing case. Make sure spare
parts are not discarded with the packing material. Inspect for damaged or
missing parts.
2-3 Recommended Storage Practice
If intermediate or long-term storage of equipment is required, it is recom-
mended that the equipment be stored in accordance with the following:
a. Within the original shipping container.
b. In a sheltered area preferably a warm, dry heated warehouse.
c. Ambient temperature 21°C (70°F) nominal, 40°C (104°F) maximum
and 7°C (45°F) minimum.
d. Relative humidity 45% nominal, 60% maximum and 25% minimum.