Connecting to a networked system – Biamp AudiaVOIP User Manual
Page 9
9
CONNECTING TO A NETWORKED SYSTEM
4. Connect the PC to the network.
There are two ways to connect a PC and AudiaVOIP system together.
Direct connection:
Attach a “crossover” Ethernet cable from the PC’s 10/100 Base-T network card to the AudiaVOIP Ethernet
port. You can easily determine if an Ethernet cable is a “crossover” by looking at the conductors on the
RJ-45 connectors. If the wiring of pins 1,2, 3 and 6 is different on both ends, it is a “crossover” Ethernet
cable.
Update the IP address and Subnet mask to the same range as the AudiaVOIP default. The IP address
should be 192.168.1.x (x=1-254). Subnet mask should be 255.255.255.0.
Click OK when complete. Close Network.
The Internet Protocol Version 4 (TCP/IPv4) Properties will open.