FlexLink X45 - Manual (Page 12)

Adjusting parameters
Create
d
by EBCCW
0
0
:06
9 5113270
7.4 Parameter files
The parameters corresponding the one or more motors can be saved in an
.xml-file for later use. Mark every node you want receive parameters from.
Chose the get parameter command. Then you can chose Save or Save as
command for saving these parameters into an .xml-file. There is also a pos-
sibility to change the comment column direct in the window. This is also
saved in the file.
In order to store a previously saved parameter file in a single motor or a
system open the file with the open command under the File menu. Then
the column New value are updated from the file. Execute the parameter
setting by the command set parameters. Then the New value column dis-
appears and the same data appears under the column online value.