EXP Computer EXP Sound card - Manual (Page 13)

- 10 -
5. The rest of the installation should proceed automatically, and the
CONFIG.SYS file on your computer will be updated automatically.
6. Now you should reboot your computer to activate the PCMCIA Sound.
Please refer to the previous section of “Hardware Installation” to make
sure the PCMCIA Sound has been connected to your system properly.
7. After the system is rebooted, you also will have to install the Windows
device driver for Sound. Go to Windows and insert the Audio
Application Software Disk #1 into a floppy drive. Run the File Manager
and select the drive containing Audio Application Software Disk#1.
Find and double-click file setup.exe. Once you see the Audio
Applications Setup window, select the Driver Installation, then select
the Custom Board Configuration button to set the proper Sound I/O
address, Interrupt (IRQ number) and DMA channel. The I/O address
and Interrupt number are the same as you selected in the INSTALL
program. The DMA should be set at 0.
Note: Due to the lack of DMA channel support in the PCMCIA structure,
some of the DOS GAME will not play Sound properly.