EXP Computer Bluetooth: Wireless HotSync of the Handspring Visor - Manual (Page 6)

Examine the “Generic Serial” service under the “Status” column. You will notice that the
service is started and that COM4 will be the next virtual COMM port that will be assigned to an
incoming Bluetooth connection.
NOTE: If you look at this display, you will see a service called .OBEX IrMC Sync..
Do not be
confused. This service is used for syncing the BTW system with other computers and
has nothing to do with HotSync on the Visor.
3.1.8 Configure HotSync on the PC
1) Right click on the HotSync Manager in your system tray and make sure only the “Local
Serial” is
2) Right click again and select “Setup…”.
3) Under the “Local” tab, select the VCOMM port that you discovered in the previous
section (in this case: “COM4”) and click on the “OK” button.