eLine Technology SNI-CamSetup - Manual (Page 18)

3. Log in Register page New User Registration
Shown in Figure 21, click on the registered account into the account registration page
22
Registered correctly complete every click.
After successful registration returns to the SETUP main interface, as shown in Figure 21
Not connect the server
，
On behalf of the network camera has been set to the registration server, but can not
connect. The most likely cause is not connected to the Internet.
Connect to the server ， On behalf of the network camera has been set to the registration server, and has been
connected.
Not set the server
，
On behalf of the network camera does not set the registration.
After successful registration, you can access anytime, anywhere, open a Web page http:// pc.easyipcam.com in the
management center logs Watch 。
(1) Server: select an appropriate registration server. (Must be consistent and the Previous set the DServer)
(2) Device ID: composed of digits and letters, a total of 20 digits. By setting interface copy obtained without having to enter from the
keyboard. ID can not be re-registered, but can be canceled and re-register a new user name and password.
(3) user name and password: the user selected. Will be used to log on to the remote control.
(4) security issues: If you forget your password, you can answer this question to reset the password.
(5) Security Answer: set password-protected answer to the question, must be properly preserved. Forget your password, you can reset your
password by answering the answer. If you can not retrieve your password, for security reasons, the user must apply for cancellation of
user name and password, re-registration.
eLine Sniper Camera Setup Manual eLineTechnology.com
17