Dynasonics D7700 Series Insertion Doppler Ultrasonic Flow Meter - Manual (Page 20)

Rev. 2/00
-3.2- 77X
5. If additional holes are required, (analog outputs,
etc.) drill the appropriate size hole in the
enclosure’s bottom. Use extreme care not to run
the drill bit into the wiring or circuits cards.
Electrical Connections
1.
To access terminal strips for electronic
connections, loosen the two screws in the
enclosure door and open the door.
2. Guide the transducer terminations through the
transmitter conduit hole located on the right side
of the enclosure. Secure the transducer cable
with the supplied conduit nut.
3. The terminals on the transducer cable are coded
with wire markings. Connect the appropriate wires
to the corresponding screw terminals in the
PART 3 - TRANSMITTER INSTALLATION
Figure 3.1