Asus A7V8X-MXSE - Manual (Page 45)

ASUS A7V8X-MX SE motherboard user guide 2-15
DRAM Timing [Auto by SPD]
It is recommended that you set this parameter to [Auto by SPD]. Setting to [Auto by
SPD] synchronizes the DRAM timing with the DRAM Clock. Setting to [Manual]
allows you to set the values for DRAM CAS Latency, Bank Interleave, Pre-charge
to Active (TRP) and Active to CMD (Trcd) prameters.
Configuration options: [Manual] [Auto By SPD] [Turbo] [Ultra]
DRAM CAS Latency [2.5]
This field sets the override clock cycle for the latency time between the DRAM read
command and the moment that the data actually becomes available. Normally, the
system determines the rate automatically by default.
Configuration options: [1.5] [2] [2.5] [3]
Bank Interleave [Disabled]
Configuration options: [Disabled] [2 Bank] [4 Bank]
Precharge to Active (Trp) [5T]
Configuration options: [2T] [3T] [4T] [5T]
Active to Precharge (Tras) [7T]
Configuration options: [6T] [7T] [8T] [9T]
Active to CMD (Trcd) [5T]
Configuration options: [2T] [3T] [4T] [5T]
DRAM Clock/Drive Control
AGP 3.0 Calibration Cycle [Enabled]
Configuration options: [Enabled] [Disabled]
DRAM Timing [Auto by SPD]
DRAM CAS Latency [2.5]
Bank Interleave [Disabled]
Pre-charge to Active (Trp) [5T]
Active to Precharge (Tras) [7T]
Active to CMD (Trcd) [5T]
DRAM Burst Length [4]
DRAM Command Rate [2T Command]
Write Recovery Time [3T]
DRAM Clock/Drive Control
F1 : Help ↑↓ : Select Item -/+ : Change Value F5 : Setup Defaults
ESC : Exit →← : Select Menu Enter : Select Sub-menu F10 : Save and Exit
Select Menu
Item Specific Help