AMX AXB-TM5 - Manual (Page 7)

Connection and Wiring
3 AXB-TM5 Television Manager
Connection and Wiring
Device DIP Switch
The eight-position Device DIP switch, shown in FIG. 2, sets the AXlink device number. Every
device on the bus must have a unique device code. An eight-position DIP switch is used to set the
device number for the AXB-TM5. The device number must match the number assigned in the
Axcess software program. The AXlink device number range is 1-255 and is sent according to the
Device DIP switch positions and their values.
As an example, FIG. 2 is set to 85 (1 + 4 + 16 + 64 = 85), which is the factory default setting.
The following table describes the Device Code DIP switch settings and its corresponding DIP
switch arrangements.
AMX standard device numbers are assigned as follows:
! Cards are 1 through 25.
! Boxes are 96 through 127.
! Panels are 128 through 255.
After setting the AXlink device number, remove and reconnect the AXlink connector
on the AXB-TM5 to store the new number into memory.
FIG. 2 Device Code DIP switch setting example
Device DIP switch settings
Position 1 2 3 4 5 6 7 8
Value 1 2 4 8 16 32 64 128
The device number takes effect only on power-up. If you later change the device
number, remove and reconnect the AXlink connector. This enters the new device
number into memory.