Datamax-O'Neil VMP-1000_2000 Dashmount Bracket - Manual (Page 2)

Cables
As s embly o f the Paper Tray:
1. Assemble the Paper Tray to the Dash Mounting Plate with
(4) #8-32 x ¼” Button head Screws with 3/32” Allen
wrench ( Fig. 13 ). Paper Tr ay ma y be installed with long
end towards the user or away from the user, depending
on dashboard configuration. The Dashmount with Paper
Tra y and Foam Block (smooth side up) should appear as
in Fig.14 .
2. Install Dashmount to dash via mounting holes and slots in
the Dash Mounting Plate.
Printer installation ( Dash mo un t Kit) :
1. Assemble the VMP-1000 printer to the Dashmount using
(4) #10-32 x 5/8” screws ( Fi g. 16 ). Tighten hardware at
the four mou nting slots at the bottom of the printer.
Secure printer to bracket w ith (1) #8-32 x 5/8 ” security
screw.
2. Route the power and data cables into the trough of the
Printer Mounting Plate as shown in Figs. 16, 17, & 18 .
As s embly o f the Vibrati on Isolation Bracket (Deluxe Kit):
1. Before mounting the Vibration Isolation Bracket (220146-
000, included in Deluxe Kit), make sure the Rubber Feet
are on the Plate correctl y. The ends of the Plate should fit
into the recess in the Rubber Feet. Put the side with the
rubber bosses closest to the edge facing up ( Fi g. 19 ).
2. Place Foot Caps on the Plate with the recesses facing up
and out.
3. Mount the b racket with (4) #10-32 x 1” screws and (4) # ¼
- 20 washers to (Fig. 20 ). Do N ot overtigh ten as it may
damage t he Foot Cap.
4. Top of screw head must clear the height of the uppermost
surface, for the printer to slide into place.
Printer installation (Deluxe Kit):
1. Note orientation of printer & locking rivets on bracket ( Fig.
21).
2. Slide printer into position until Locking Snap “clicks” ( Fi g.
22).
3. Secure the printer to bracket with either the supplied #8-
32 security screw (special bit T15 Torx w/ security pin
required) or # 8 Phillip s pan
-
head self-locking screw
.
4. Route the power and data cables as shown in Figs. 16,
17, & 18.
6
F ig. 22 Locking rivets Fig. 21
Locking Snap
Security/Phillips
screw
F ig. 17
Cables
F ig. 18
Cables
10-32 x 5/ 8”
Scre w
Trough
Security
Screw
Fig. 16 Mounting holes Fig. 15
F ig. 14
#10-32 x 1” &
#¼ - 20 Washer
Fig. 20
Foo t Cap
R ubber Foot
F ig. 19
F ig. 13
5
Cables
Dashmount Bracket
VMP1000/2000
110092-002