Datamax-O'Neil microFlash 4t_4te External Charger Swivel Lock - Manual (Page 2)

Attaching the Printer(s)
1. Place the printer's swivel mount block over the
unlocked swivel lock bracket (Figure 9).
2. Facing the printer, move the swivel lock lever from
left to right until it “clicks” into the locked position
(Figure 10).
Warranty
The Company warrants that Datamax-O’Neil, products are free
from defects in manufacturing materials and workmanship for one (1)
year from date of original purchase to Buyer/Distributor (OEMs 90 days from
the date of purchase). Batteries, cables, power supplies, and other
accessories will be warranted for ninety (90) days. Datamax-O’Neil
makes no other warranties, expressed or implied, including
implied warranties of merchantability and fitness of purpose.
If you try to repair, disassemble, or change the product in any way, or use
parts not provided by Datamax-O’Neil without prior, written authorization, all
warranties are void. For complete warranty and service information, see the
Warranty Card included in your printer's original packaging.
No Liability for Negligent Use
In no event shall Datamax-O’Neil be held liable for any damages
whatsoever (including, without limitations, damages for loss of
profits, business interruption, loss of information, or other pecuniary loss)
arising out of negligence in use and care of the product.
Figure 9 Figure10
Attaching the Power Supply
Use the following procedure to attach the power
supply to the depot charger . If the power supply is
already attached to the depot charger , proceed to
Attaching the Printer(s).
1. Insert the AC Adapter into the
depot charger 's AC
Adapter cradle (Figure 6).
2. Plug the AC Adapter's connector into the depot
charger 's power supply cable socket (Figure 7).
3. Plug the Grounded AC Adapter’s connector into
the AC Adapter's socket (located on the AC
Adapter cradle). Verify the 3-prongs of the
Grounded AC Adapter's connector match the AC
Adapter's socket (Figure 7).
4. Plug the Grounded AC Adapter cord to an outlet.
5. Plug in the external charger at each location
(Figure 8).
Note: Make sure you regularly clean the
charging contact points on your printer's case
to ensure your printer's batteries are properly
charged and avoid damage to printer or
charger. To clean the charging contact points,
unplug the charger from the wall and clean
using alcohol and a clean rag.
Figure 6
Figure 7
Depot charger's power supply
cable socket
Depot charger's AC Adapter
cradle
AC Adapter
Grounded AC Adapter
AC Adapter 3-prong socket
AC Adapter's connector
Figure 8
Swivel Lock External Depot Charger Rev1.fm Page 2 Wednesday, October 12, 2005 11:02 AM
MICROFLASH
4
T
External Charger Swivel Lock
110164-002