AmpliVox SW915 - Manual (Page 8)

8
BATTERIES
1. Hold the body of microphone in hand and twist off bottom
section of microphone.
2. Insert two “AA” batteries.
3. Twist bottom section back on to microphone.
BATTERY STATUS
The life expectancy of the two batteries is about 10 hours. When
the
“BATTERY” symbol on the display screen keeps flashing
the batteries should be replaced immediately.
·
Channel Display (A)
·
RF - Radio Frequency Indicator (B)
·
AF - Audio Frequency Indicator (C)
·
ASC / IR Auto Channel Select (Handheld Only) (D)
·
Select Buttons - Manual Channel Selection (E)
·
Mute Level Adjustment (F)
·
Volume Control (G)
R ECEIVER / T RANSMITTER S ETUP:
·
The receiver has its own POWER / VOLUME Control (G).
First make sure that you have screwed on the UHF antenna.
Turn Power On. A Frequency Channel will appear in the
Channel Display
(A). Press Select Buttons (E) to select a
channel. Channel number must match channel number on
wireless transmitter.
·
The transmitter bodypack is operated by 1 - "AA" 1.5 Volt
alkaline battery. Slide off battery cover
(H) and install battery
as shown. Make certain the battery is fully seated in its com-
partment so the cover slides in place easily. Battery life with
alkaline batteries is approximately 8 hours of operating time.
·
Select a channel (1-16) on side panel (I) using the supplied
screw driver to select channel number. Channel selected
should match channel on receiver. When transmitter and
receiver are set to correct channel the RF indicator
(B) will
glow red when transmitter is turned on.
·
Plug the Lapel microphone into the Mic Input Jack (K). The
microphone can be clipped to a necktie or other clothing,
using the supplied clip. The lapel mic should be placed under
the chin, as close to the center of the body as possible
·
Slide the power ON/OFF switch (J) to the ON position (the
LED indicator light will illuminate green). Replace batteries
when this LED turns red.
● MUTE LEVEL (F) is set at half way mark when it leaves the
factory. If speaker sound is breaking up, turn level clockwise
with small screwdriver until condition improves.
Battery Cover Channel Selector
Top Panel
16 CHANNEL UHF WIRELESS
Wireless Transmitter - Bodypack
W IRELESS R ECEIVER P ANEL
G F
D
E
C A B
H
I
J
K
If you are using the Amplivox S1695 Wireless Handheld Microphone Transmitter, screw off the lower bottom section of microphone
and insert 2 - "AA" 1.5 Volt alkaline batteries.
Because the microphone has an Auto Sync function, you first select channel you wish to use on the receiver. Then press the ASC
button (
D), the IR light will start to flash. Turn on microphone and point end (6) of microphone at the flashing IR light on receiver and
the microphone will auto sync to the same channel as selected on the receiver.
WIRELESS HANDHELD MICROPHONE—MODEL S1695
6