AmpliVox SW915 User Manual

Page 3

1. Power unit on with rocker switch. The display will light
with

MASTER VOLUME indicated.

Display will go black after one minute

’s inactivity to

preserve battery power. Display will illuminate with a
press of any button.

2. Use the remote or the

UP and DN buttons on the control

panel, to select a function.

3. To change the level of a selected function, press the
ADJUST button. ADJ will appear on the display. Press UP
or

DN button to obtain desired level, then press SAVE .

4. Use

UP and DN buttons to cycle through BASS , TREBLE,

DUCKING , REVERB, VOICE, and all VOLUME controls;
then

ADJUST and press SAVE .

5. The

WIRELESS RECEIVER has its own POWER / VOLUME

Control. Before you turn on the receiver, screw on the UHF
Antenna. Turn Receiver Power

On. A Frequency Channel

will appear in the Channel Display. Press

UP/DOWN Buttons

to select a channel. Channel number must match channel
number on wireless transmitter.

Wireless Bodypack Transmitter- Before turning on the

transmitter, use the provided screwdriver to set the transmit-
ter channel selector switch to the same number that is dis-
played on the receiver. Select channels 1-16. Install 1 -

“AA”

battery into battery compartment of wireless transmitter pack.

MAIN BATTERY STATUS indicator - Red = no battery

power, Yellow = 1hour left. Charge battery overnight for best
results.

If you need further assistance, please call
1-800-267-5486, 8am-6pm M-F CST .

Getting Started/Quick Setup (Also Printed on Battery Cover)

SW915 SPECIFICATIONS

Rated Power Output

250W Dynamic, 132W RMS

Battery

(2) 12 volt rechargeable, 7.2 AH,

User accessible and replaceable

AC Power

110-220 Auto sensing, 50/60 Hz,

Phantom Power Input

Powers Electret condenser microphones

Wireless Range

Up to 300 Feet

UHF Wireless Frequency 584—608 MHz

Frequency Response: 40Hz to 20Khz

Sensitivity

96dB

Equalization (tone)

Separate Bass and Treble

Line output:

Buffered, 600 ohm, 1/4in.jack (pre fader)

Sensitivity for rated output:

Balanced Microphone

-58 dBV (1.25 mVrms

Balanced Line

-15 dBV (175 mVrms)

Unbalanced line

-20 dBV (100 mVrms)

Unbalanced input:

Hi-Z, Neutrik combo - 1/4in.

Balanced Input:

Lo-Z, Neutrik combo XLR

Weight:

35 lbs.

Dimensions (HWD ):

23in.H x 11.5in. W x 11in. D

Warranty

6 years Electronics; 1 year on

Remote, Microphones, Cassette

Player, CD Player, Digital Player

and Rechargeable Batteries.

PLEASE NOTE: THE REMOTE DOES NOT
TURN THE UNIT ON OR OFF. YOU MUST
DO THAT ON THE CONTROL PANEL