Ultra Start 600 Series - Manual (Page 7)

Program mode allows you to adjust the settings and options of your system.
Your system has been intelligently designed by installers with years of experience. The system’s
default settings do not require any program changes in most cases. However, this system does
incorporate a highly advanced programming system that includes 2 menus with numerous options
and settings that can be easily adjusted for custom installations and applications.
Entering Program Mode
Changing the Programmable Settings
To Enter Program Mode
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON - OFF - ON - OFF - ON. Leave Key ON.
3) Press and release the Program Button one time.
4) Park lights will come and the siren will chirp to confirm entering Program Mode.
5) Select Desired Program Menu by the following:
Press Button #1 Lock User Options Page 8.
Press Button #2 Unlock Alarm Settings Page 9.
6) The selected mode will be confirmed by a siren chirp and one park light flash.
7) The Program Menu may be changed at any time by pressing the transmitter buttons as
above, this allows the installer to change a setting from one menu, then quickly jump to
another menu and change another setting without exiting Program Mode.
8) Program Mode will be exited if there is no activity for 30 second or if the key is turned to the
“Off” position. This will be confirmed by one siren chirp and park light flash.
Note: If unit does not enter Program Mode, turn ignition off and repeat steps 1-4.
** The ignition wire(Yellow) MUST be connected to the vehicle’s ignition wire. If it is not
connected it will not be possible to enter the Program Modes.
To Select and Change A Program Setting:
1) Enter Program Mode.
2) Select the desired Program Menu. (See pages 8&9)
3) Press & release the Program Button the correct number of times to select the desired
Program Setting(as listed on pages (8&9). The park lights will flash and the siren will chirp to
indicate the current setting that is selected.
4) Press and hold the Program Button until the parking lights / siren confirm the selected setting.
The park lights will flash and the siren will chirp to indicate the option selected within the setting.
5) Turn the ignition key “Off” to exit Program Mode.
SYSTEM RESET
STEP 1 - Within three seconds turn the key ON-OFF-ON-OFF-ON (Leave the Key ON).
STEP 2 - Press and release the Program Button.
STEP 3 - Park Lights will come ON
STEP 4 - Press the Program Button a second time and hold for 8 seconds until the park lights
flash 3 times and siren chirps 3 times.
System is now re-set to factory defaults.
NOTE: Reset to defaults does not delete the transmitters from memory.
Programming Overview
PAGE 7
SECURITY SYSTEM
INSTALL GUIDE