Contemporary Research QMOD-HD TV One Integration - Manual

Setting up a QMOD-HD/TV One Digital Signage System
Overview
Designed to broadcast the output of a digital signage player as a digital cable channel, a QMOD-HD/TV One
Scaler system includes the following components:
 QMOD-HD HDTV Modulator
 TV One 1T-C2-400 VGA Scaler
 RK1-AC QMOD Rack Kit with Accessory Shelf
Components You Need
You’ll need a few parts essential to setup. Initially, you will set up using a direct RF connection to a TV. Once you
know the system is operating; then the system will feed a channel to the house system.
 2 HD15 to HD15 monitor cables
 1 Mini to Stereo RCA audio cable, if audio is needed
 1 Flat-Panel TV with onboard HDTV tuner and a PC RGB connection
 1 RF cable with “F” connectors
 1 Digital Signage PC with HD15 output, ideally, pre-loaded with the client digital signage program
Ideally, use one of the site’s TVs to test the system before it’s inserted into the RF system. That’s the best
approach, but not always possible. That’s why it’s good to have one of your own, just in case.
If you have an Apple or WIN7 PC, you’ll likely need an EDID emulator for a 1980 x 1080 PC resolution. That’s
because both restrict resolution if the OS can’t see the EDID data from the scaler. Emulators include ConnectPro
VGA-EDID , Kramer VA-GAN , and Hall Research EM-EDID-HD-15 .
Assembly
 Attach the RK1-AC shelf and rack bracket to the QMOD-HD using the supplied black screws
 Attach the included rubber feet to the TV One scaler
 Mount the TV One C2-400 to the accessory shelf with the included two small Philips screws
 Attach an HD15 monitor cable from the TV One PC/HD Scaled Out port to the RGB connection on the
QMOD-HD
 Attach another HD15 monitor cable from the signage PC to the TV One PC/HD IN connection
 Attach a mini to RCA stereo cable from the PC audio out to the RCA Stereo In on the QMOD-HD – if
audio is needed
 Connect power to both units
Start PC and Signage App
Connect the PC to the TV (or its own monitor), start up the PC and run the signage app. You will use this video
for system setup. Remove the HD15 from the TV, and connect it to the TV One PC/HD IN connector.