CHIEF MAC251 - Manual (Page 2)

MAC-251 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Exceeding weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components does not exceed the maximum allowable
weight of the mount to which the MAC251 is being installed.
DIMENSIONS
13.85
351.91
1.50
38.10
2.50
63.50
12.60
320.16
3.94
100
3.94
100
APPROXIMATE CENTER
OF DISPLAY
13.75
MAXIMUM EQUIPMENT SIZE
349.25
5.94
150.80
1.50
38.10
1.25
31.75
3.88
MAXIMUM EQUIPMENT SIZE
98.43
4.66
ADDED DEPTH TO MOUNT
AND MSB-XXXX INTERFACE
BRACKET
118.39
.88
22.23
2.50
63.50
1.75
44.45
9.00
228.60
NOTE: MOUNT AND CUSTOM INTERFACE
BRACKET NOT SHOWN. SEE DRAWING FOR
MOUNT AND MSB-XXXX FOR ADDITIONAL
TECHNICAL INFORMATION
DIMENSIONS: [MILLIMETER]
INCH