CHIEF PAC200 - Manual (Page 4)

Model: PAC-200 Installation Instructions
4
INSTALLATION
REMOVE EXISTING PPC COMPONENTS
WARNING: Display is very heavy! Ensure display can
be safely lifted and maneuvered as required for
removal. Failure to take adequate precaution can
result in serious personal injury or damage to
equipment!
1. If display is attached, then perform the following in
order:
• Lock PPC Cart casters
• Disconnect cables from display
• Remove display
See instructions included with PPC Cart. Do NOT
remove interface from display.
2. Using hex key (60), remove eight 1/4"-20 x 5/8" button
head cap screws attaching faceplate side brackets to
single mount head (See Figure 2). Do NOT remove
side brackets from faceplate. Retain screws and
faceplate/side bracket assembly for later use.
NOTE: 1/4"-20 nuts will not be reused in PAC-200
installation.
Figure 2: Remove Faceplate/Side Bracket Assembly
3. Using hex key (60), remove four 1/4"-20 x 5/8" button
head cap screws attaching single mount head to leg
brackets (See Figure 3). Retain screws for later use.
NOTE: Single mount head will not be reused in PAC-200
installation.
Figure 3: Remove Single Mount Head
1/4"-20 x 5/8"
Screws (8 places)
Single Mount Head
Nuts (8 places) Faceplate
Side Brackets
(2 places)
Faceplate
1/4"-20 x 5/8"
Screws (4 places)
Leg Brackets
Single Mount Head