ADS Technologies USB Instant DVD - Manual (Page 44)

42 VIDEOSTUDIO USER GUIDE
Configuring VideoStudio
Camcorders, VCRs, and VCD/DVD players are common sources of video footage. To ensure
a smooth interaction between these video sources and your computer, make sure that the
settings of VideoStudio are configured properly depending on the capture device you are using.
Check that your device is listed under Driver
Instant DVD Setup
To check the setup of VideoStudio for analog
interface:
1. Connect your camcorder, VCR, or other video
source device to your analog capture card.
2. Insert your videotape into the capture device
and switch it on. Make sure it is in the
playback mode (usually named VTR or
VCR). See your machine’s manual for
specific instructions.
3. The Instant DVD Capture plug-in will be
detected automatically.
4. Click Capture Step at the top of Video Studio
software and check if your device is dis-
played in the Options Panel under Driver.
5. To change video source (RCA or S-VHS),
NTSC or PAL, brightness and color controls,
click the Options button (Gear icon). Select
Video Properties
and click Video Capture Pin. Make your
changes and click OK to close the dialog
box.
Note: Instant DVD supports
multiple video sources.
The Video Properties dialog box
allows you to select your desired
video source such as Compos-
ite or S-Video. You can also
make changes to color and
brightness settings to video
being captured via Instant DVD.
VS6-A.p65 6/4/2002, 12:22 PM 42