CHIEF K1P Series - Manual (Page 9)

Installation Instructions K1P Series
9
Handle Installation (K1P22 model only)
1. Loosen four screws securing handle brackets to K1P22
array. (See Figure 7)
2. Install uprights of handle (J2) into handle brackets located
on the back of array. (See Figure 7)
Figure 7
3. Position handle (J2) at desired height and secure by
tightening button head cap screws attaching handle
brackets to array. (See Figure 8)
Figure 8
Adjustments
Pitch Adjustment (non-array models)
1. Adjust pitch to desired tilt position. (See Figure 9)
2. Adjust pitch tension screw to change the adjustment
tension. (See Figure 9)
Pivot Adjustment (non-array models)
3. Adjust pivot position as desired. (See Figure 9)
4. Use 3/16” hex key (L) to adjust pivot point tension screws to
change pivot adjustment tension. (See Figure 9)
Figure 9
Rotational Adjustment
NOTE: (Optional) Rotational adjustment may be locked by
installing rotational locking screw (H) into back of
faceplate. (See Figure 10)
Figure 10
5. The monitor may be adjusted 90 degrees in either direction
in order to provide a portrait view of the monitor. (See Figure
9)
6. Use 3/16” hex key (L) to adjust rotational adjustment screw
to adjust rotational tension. (See Figure 9)
2
2
(J2)
1 x 4
3
3
3 x 4
pitch
pivot point
tension
tension
5
1
3
Rotational tension
(H)