CHIEF K1P Series - Manual (Page 10)

K1P Series Installation Instructions
10
Lift Arm Tension Adjustment
1. Use 3/16” hex key (L) to adjust lift arm tension adjustment
screw. (See Figure 11)
Figure 11
NOTE: Tension may also be adjusted with upper tension
adjustment screw inside cable management cover and
1/8” hex key (M). (See Figure 12)
Figure 12
Adjustments - K1P22H models only
1. Loosen knobs securing faceplates to array. (See Figure 13)
2. Slide displays laterally on array to adjust lateral shift. (See
Figure 13)
3. Adjust pitch and pivot position as desired. (See Figure 13)
4. Tighten knobs to secure faceplates in position. (See Figure
13)
Figure 13
Array Bar Roll Adjustment
1. Loosen roll adjustment screws on back of array bracket.
(See Figure 14)
2. Adjust roll of array bar as desired. (See Figure 14)
3. Tighten roll adjustment screws on back of array bracket.
(See Figure 14)
Figure 14
K1P110
K1P120
1
Reduce tension
Increase tension
(lighter display)
(heavier display)
Do NOT over-tension
adjustment tension
screw.
Reduce tension
Increase tension
(lighter display)
(heavier display)
Do NOT over-tension
adjustment tension
screw.
2
3
2
1 4
3
3
3
1 3
2
2