CHIEF K1P Series User Manual
Page 11
Installation Instructions
K1P Series
11
Display Removal
WARNING:
Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 15)
1.
Make sure display is in the upright position.
2.
Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 15)
Figure 15
Pivot Adjustment Range
Single Arm Models
1.
Adjust arm angle as desired up to 90 degrees in either
direction. (See Figure 16)
WARNING:
Swinging the arm beyond 90 degrees may
result in the mount slipping off the desk causing serious
injury!
Figure 16
Dual Arm Models
1.
Adjust arm angles as desired within a 90 degree range from
the pivot point of the arm and a perpendicular centerline of
mount. (See Figure 17)
WARNING:
Swinging the arm beyond this range may result
in the mount slipping of the desk causing serious injury!
Figure 17
quick release tab
2
(top view)
+/- 90 degrees range
of motion
pivot point of the arm
perpendicular centerline
90 degrees range
of motion per arm
pivot point of the arm
(top view)