CHIEF F-Series - Manual (Page 4)

Model: F-Series Installation Instructions
4
MOUNT INSTALLATION
INSTALLATION TO WALL
1. Verify that you have the following parts:
2. Determine location for mount keeping in mind display
size, extension, height adjustment (if applicable), and
pitch/roll requirements. Bracket (20) MUST be
installed into wood stud.
3. Using bracket (20) as a template, drill two 1/8"
diameter pilot holes through top and bottom holes of
bracket (20) into wall structure (See Figure 1).
Figure 1: Install Wall Bracket
4. Using 7/16" wrench, install screws (30) through
washers (40), bracket (20), and drywall into wood
stud (See Figure 1). Ensure bracket (20) is vertical,
then tighten screws (30).
IMPORTANT ! : Overtightening screws (30) may cause
bracket (20) to compress into soft wall surface, resulting
in difficult mount installation or improper engaging of set
screw in step 6.
IMPORTANT ! : IF you will be installing a SINGLE
display with RECESSED mounting holes, then proceed
to "DISPLAY INSTALLATION" before continuing with this
mount installation procedure.
5. Insert top of mount (10) over lip on top of bracket (20)
(See Figure 2). Swing mount (10) down flush against
wall.
Figure 2: Install Wall Mount
6. Tighten set screw using 5/32" hex key (See Figure 3).
Ensure set screw engages back side of bracket (20)
to properly secure mount.
Figure 3: Tighten Set Screw
7. Proceed to "CABLE MANAGEMENT" (for SINGLE
display with RECESSED mounting holes), or to
"DISPLAY INSTALLATION" (for all other display
configurations).
Item Description Qty
10 MOUNT, Wall, F-Series 1
20 BRACKET, Wall 1
30 SCREW, Hex Head Lag, 1/4" x 2-1/2" 2
40 WASHER, Flat Machine Screw, 1/4" 2
30
40
20
10
20
NOTE: FWS-110 shown; other wall mounts similar.
NOTE: FWS-110 shown; other wall mounts similar.
Set Screw
20