CHIEF PCS Series - Manual (Page 5)

Installation Instructions PCS Series
5
INSTALLATION
WARNING: FAILURE TO PROVIDE ADEQUATE
STRUCTURAL STRENGTH FOR THIS COMPONENT CAN
RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE
TO EQUIPMENT! It is the installer’s responsibility to make
sure the structure to which this component is attached can
support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
IMPORTANT ! : These installation instructions assume
that a 1-1/2" NPT or NPSM following ANSI/ASME
B1.20.1 (Schedule 40, 0.154" minimum thickness steel or
aluminum - ASTM B221) threaded extension column (not
included) has been properly installed and is in place.
Attaching Mount to Extension Column
CAUTION: Watch for pinch points. Do not place fingers
between movable parts.
1. Thread the PCS mount (A) onto the existing 1-1/2" NPT or
NPSM pipe (not included) until tight, with a minimum of four
threads engaged. (See Figure 1)
2. Install and tighten the 5/16-18 x 3/8" set screw (B). (See
Figure 1)
Figure 1
Attaching Interface Bracket to Display
1. Attach PSBU interface bracket to display following
instructions included with interface bracket kit.
Attaching Display to Mount
1. While supporting both sides of display, align four mounting
buttons on interface bracket with four mounting holes in
PCS (A). (See Figures 2, 3 and 4)
Figure 2
WARNING: DISPLAY MAY WEIGH IN EXCESS OF 40
LBS! Always use two people and proper lifting techniques
when installing or positioning display on PCS.
2. Lower display into place listening for audible "click" to
ensure recessed area of mounting buttons are properly
seated in lower area of mounting holes, and ClickConnect
mechanism has engaged. (See Fig. 2, 3 and 4)
Figure 3
WARNING: IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Ensure mounting
buttons are completely engaged in mounting holes.
(A)
Extension
2
1
(B) x 1
column
(not included)
1
(A)
Display
(A)
Back
of Display
PSBU
interface bracket