CHIEF TS525TU User Manual
Page 15
Installation Instructions
TS525TU
15
Arm Tension Adjustment
1.
Use 1/4" hex key (AA) to adjust arm tension at any of the
four arm tension adjustment points. (See Figure 25)
Figure 25
2.
Use 9/16" wrench to adjust arm tension directly behind
faceplate. (See Figure 26)
Figure 26
Install Interface Bracket Adhesive Covers
(Optional)
If the interface bracket was required to install display to mount,
adhesive covers may be used to cover the holes on the
interface bracket in order to improve the appearance.
1.
Use two long adhesive strips (CC) to cover vertical uprights.
(See Figure 27)
2.
Use four short adhesive strips (DD) to cover horizontal
upright supports. (See Figure 27)
NOTE:
These strips may be cut as desired in order to fit around
screws.
Figure 27
arm tension
adjustment points
not adjustable
with hex key
arm tension
adjustment points
(DD) x 4
(CC) x 2
1
2