CHIEF TPP Series - Manual (Page 9)

Installation Instructions TPP Series
9
(Optional) Locking Angle Tilt Holes
The TPP can be tilted up to 15 degrees, and features three
holes used to set specific tilt (0°, 5° and 10°).
1. Loosen tilt adjustment screws, adjust to desired tilt, and
tighten tilt adjustment screws. (See Figure 11)
2. Install 1/4" fastener (Grade 2 or better) (not provided) into
desired degree tilt hole (See Figure 11):
• 0° (outside hole)
• 5° (middle hole)
• 10° (inside hole)
Figure 11
Removing the Display
WARNING: IMPROPER HANDLING CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Inadequate support
of display while removing it may cause display to fall! Watch
for pinch points. Do not put your fingers between movable
parts.
WARNING: Ensure Q-Latch flag securing display is
completely raised at all times except when removing or
installing display. The flag must be all the way up when
installing or removing cables.
1. With display securely supported, unlock display from TPP
(A) by lowering the flag all the way down to the unlocked
position. (See Figure 12)
Figure 12
2. Using two people, slide display up and out of TPP (A). (See
Figure 13)
Figure 13
Tilt adjustment screws
1 x 2
0° tilt hole
5° tilt hole
10° tilt hole
2
Unlocked
(A)
Locked
1
(A)
(A)
Display
2
(Q-Latch
slots) x 4