CHIEF TPP Series - Manual (Page 8)

TPP Series Installation Instructions
8
1. Attach PSB interface bracket (B) to display using the
instructions included with the PSB package.
2. Using two people, slide display with attached interface
bracket (B) down over the four slots in the faceplate of the
TPP (A). Make sure all four mounting buttons engage all
four Q-Latch slots in the TPP (A). (See Figure 8)
Figure 8
3. With the mounting buttons of the display fully engaged in
the slots of the TPP (A), secure the display on the TPP by
raising the flag all the way up to the locked position. (See
Figure 9)
Figure 9
4. If the flag does not fully engage, remove the display and
make sure all four mounting buttons are fully engaged in
slots.
NOTE: A security lock may be installed through the hole in the
Q-Latch flag for added security. See (Optional)
Security Lock section.
Tilt Adjustment
WARNING: IMPROPER HANDLING CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Inadequate support
of display while adjusting tilt may cause display to fall! Watch
for pinch points. Do not put your fingers between movable
parts.
1. Loosen tilt adjustment screws, adjust to desired tilt (up to
15°), and tighten tilt adjustment screws. (See Figure 10)
Figure 10
(B)
(A)
(Q-Latch
slots) x 4
Latching flag
Display
2
(on other side)
(A)
Locked
Display
Mounting buttons in slots (x 4)
Note: Trusses not
shown for clarity.
3
(B)
Tilt adjustment screws
1 x 2
Note: Interface bracket, display and
trusses not shown for clarity.