CEMB USA C71_2 (A) User Manual

Page 7

POS. A

POS. B

I 0439 -

5 - Instructions for use of the wheel balancer

5.1 - Using the gauge installed on the machine

5.1.1 - Data setting

For clamp weights, use the gauge in the top position A.
For adhesive weights, use the gauge as preferred in top position A or
bottom position B.

Note: Always use the round part of the striker plate resting on

the rim.

Indication of gauge in movement

5.2 - Automatic presetting

The machine automatically detects the correct balancing program for steel and aluminium rims (ALUS).

The counterweight position proposed may be changed using the two

ALU

buttons.

5.2.1 - Steel or aluminum wheel rims. Sprung counterweights

Pull out the gauge as far as the inner edge of the rim. Hold it in this
position until a “beep” is heard.

Indication of dimensions acquired

Return the gauge to rest position. The machine has automatically

detected DISTANCE + DIAMETER and goes to MANUAL WIDTH

SETTING.

- The nominal width is normally stamped
on the rim; if not, proceed to measure
dimension “b” with the calibre gauge

(supplied as standard).