CEMB USA C72_2SE (A) - Manual (Page 10)

I 0186 GB - 10
Pos. A
Pos. B
5 - INDICATIONS AND USE OF THE WHEEL BALANCER
5.1 - DOUBLE OPERATOR PROGRAM
This program allows memorizing the dimensions of two types of wheels. Thus two operators can work
simultaneously on two different cars using the same balancing machine. The system memorizes two
programs with various preset dimensions.
1 - Press to select operator (1 or 2). Selection is confi rmed by panel-mounted LED.
2 - Enter the dimensions (see PRESETTING OF WHEEL DIMENSIONS )
3 - carry out the balancing as usual
With program 1 or 2 is called for subsequent balancing operations without having to newly enter
the dimensions.
5.2 - PRESETTING OF WHEEL DIMENSIONS
5.2.1 - AUTOMATIC PRESETTING
- Standard wheels (calibration necessary also for modes ALU 1, 2, 3, 4 Static)
Fig. 8 DISTANCE + DIAMETER
Move the gauge tip into contact against the rim keeping it in
position for at least 2 seconds.
N.B. Measurement is the same in position A or B. Always use
the round part of the contact tip.
Indication of gauge in movement
Indication of dimensions acquired.
N.B.: When the beep signal is enabled (see section CONTROL
OF THE FUNCTIONS MENU ), reaching of the dimensions is
accompanied by a “beep”
Return the gauge to position 0. If automatic WIDTH readout is
disenabled (see
GAUGE ENABLE ), the system automatically goes to the
WIDTH position.
The system automatically switches to WIDTH position
Fig. 6
- The nominal width is normally stamped
on the rim; if not, proceed to measure
dimension “b” with the calibre gauge (supplied
as standard).