CEMB USA C73 (A) - Manual (Page 12)

I 0567 - 12
9
FE FI
GB
5.3.1.3 - Wheels ALUS
After the measurement performed for the FI inner side, as indicated in fi g. 9, pull out the gauge again to store the
data for the FE outer side; choose position A or B (fi g. 8) at your choice. Keep this position for at least 2 seconds.
The counterweight symbols change colour.
When the acoustic signal is enabled (see
ACOUSTIC SIGNAL ), the acquisition is accompanied by a “beep”.
►
After having detected the dimensions, use the key to indicate the type of correction selected for the inner
side.
The following buttons are enabled:
Position of
adhesive
weights
Management of save user recall
Selection of clip or adhesive weight for inside.
Only for automatic width option:
The
L.T. key (LIGHT TRUCK) used to improve the dimensional calibration of large-diameter
wheels such as off-road, trucks, wheels which protrude signifi cantly from the rim. Press the L.T. key,
after distance measurement, immediately before lowering the guard for Width Measurement.
The option is disengaged at the end of current Width Measurement.
Selecting the manual dimension presetting screen
Return to initial screen.
Balancing run.