CEMB USA C29_2 (B) - Manual (Page 4)

2 2a
I 0533 - 4 GB
1.4 - Technical data
Note: DO NOT LIFT THE WHEEL BALANCER USING OTHER GRIPS.
Single-phase power supply 230 V - 50/60 Hz AC - 12/24 V DC
Protection class IP 54
Max. power absorbed 0,03 Kw
Balancing speed < 100 min -1
Cycle time for average wheel (14 kg) 6-8 seconds
Max. resolution of measurement 1 gram
Position resolution ± 1.4 °
Average noise < 70dB (A)
Rim-machine distance 0 - 210 mm
Rim width setting range 1.5” - 20” or 40 - 510 mm
Diameter setting range 10” - 30” or 265 - 765 mm
2 - Handling and lifting
3 - Startup
3.1 - Anchoring
The machine can operate on any flat non resilient floor.
Make sure that the machine rests solely on the three support points provided (Fig.2a).
3.2 - Electrical connection
The machine is provided with net supply (AC) and cable for battery supply (12-24VDC).
The supply voltage (and mains frequency) is given on the machine nameplate. It cannot be changed.
The machine should not be started up without proper earthing.
Connection to the mains should be through a slow acting safety swich rated at 0.5 A (230V). See attached diagram.