Installation, 1 cleaning, 2 ambient characteristics – CEMB USA ER85 Installation Manual User Manual
Page 9: 3 fitting the adapters, English

ENGLISH
Installation manual Rev. 03-2012
9
4. Installation
WARNING
THE
INSTRUCTIONS
IN
THIS
CHAPTER
ADDRESS
THE
OPERATOR
WHO
MUST
OPERATE
WEARING
THE
PERSONAL
PROTECTION
DEVICES
INDICATED
IN
CHAPTER
2.
4.1 CLEANING
Before starting the machine, clean off any dust, foreign matter and soiling that may have accumulated during transport.
Use alcohol to clean the plastic parts.
CAUTION:
D
O
NOT
USE
LIQUIDS
CONTAINING
SOLVENTS
OR
BLASTS
OF
COMPRESSED
AIR
TO
CLEAN
THE
WHEEL
BALANCER
.
4.2 AMBIENT
CHARACTERISTICS
The operating environment must have the following characteristics:
Temperature:
▪
+ 5 to + 40°C (41 - 104°F)
Maximum relative humidity
▪
: 80%
The machine may not be used in open places and/or exposed to atmospheric agents or in environments with corrosive
and/or abrasive vapours, fumes or dust with the risk of fire or explosion, and in any case where the use of explosion-
proof components is prescribed.
CAUTION:
S
HOULD
AT
THE
TIME
OF
INSTALLATION
THE
AMBIENT
CONDITIONS
BE
DIFFERENT
FROM
THOSE
PRESCRIBED
,
OR
IF
THEY
HAVE
CHANGED
OVER
TIME
,
DO
NOT
USE
THE
MACHINE
BUT
IMMEDIATELY
CONTACT
THE
MANUFACTURER
FOR
THE
RELATIVE
INSPECTION
.
4.3
FITTING THE ADAPTERS
Installation
INFORMATION
Before fitting the terminal to the wheel balancer, thoroughly
clean the machine shaft and the adapter hole. Any traces
of dirt or incorrect locking may affect balancing accuracy.
The wheel balancer is supplied complete with adapter and
cones for fastening wheels with a central hole. The threaded
terminal must be fitted during machine installation using the
Allen wrench provided applying the correct tightening torque
(20-25Nm). If it is a machine with pneumatic locking, follow
the procedure indicated in the use and maintenance manual.
In both cases, it can be removed for fitting any optional
adapters.