Hunter 99050, 99051,99052, 99053, 99054, 99055 Decorative Low Profile Integrated Kit - Manual (Page 7)

MA007-01 • 07/26/13
1.888.830.1326
7
After the light kit is mounted to the fan, feed
the pull chains from the fan’s switch housing
and the light kit through the grommeted
holes in the base of the light kit. Extension
chains are provided, if necessary. Both pull
chains must line up with the grommeted
holes to operate properly.
Grommeted
Hole Pull Chain
TYPE-B ASSEMBLY INSTRUCTIONS (CONTINUED)
Indentation
Tab
Installing the bulb - Install a bulb into each
of the sockets. When necessary, replace
with bulbs of the same type and wattage.
Socket
Installing the Pull chain pendant -
Attach the pull chain pendant to the
end of the short chains coming from the
switch housing and the light kit. Turn
power on. Your installation is complete.
5
7
6
8
Installing the globe (sold separately)- Position the
indentations in the outer rim of the globe so that they
line up with the tabs on the inside surface of the light
fixture rim. Carefully lift the globe up inside the light
fixture as far as it will go. Rotate the globe in a clockwise
direction until it is held tightly in place by the four tabs.