American Panel HURRICHILL AP20BC175-2 - Manual (Page 29)

AP20BC175-2 Manual
28
y installed
on the groove patterns to pop the front edge up. Lift off
will facilitate the entry of the paper into
d hold
e.
with the spindle onto the snaps
REMOVING A ROLL OF PAPER
the paper about one inch beyond the paper cutter.
he
W r out from the back of the printer will damage the print
G THE PRINTER
s a rocker type switch. Push the left side of the rocker switch
s difficult to see, replace the ribbon in your printer with an Epson HX-20
EPLACING THE RIBBON (NO PAPER IN THE PRINTER)
OTE: The optional printer is delivered full N
OADING A ROLL OF PAPER L
1. Remove the paper cover by pressing
the cover.
2. Press the rocker switch to the left. The light will go off.
3. Unroll several inches of paper.
r roll if it is jagged. This 4. Cut a straight edge on the pape
the printer.
5. Slide the paper (with the roll above the paper) through the slot connecting the paper
compartment and the printer compartment. It can be slid in about 1/4” before it stops.
6. While holding the paper in place, press the rocker switch to the Paper Feed position an
it there. The printer will activate and a rubber roller will pull the paper into the printer
compartment. Release the switch when an inch of paper has emerged from the top of the
printer.
7. Slide the paper through the slot in the printer cover.
8. Push the back of the printer cover down and into plac
9. Press the front of the printer cover down to lock in place.
10. Put the paper spindle into the paper roll and place the roll
near the back of the printer. Turn the paper roll to take up any slack. Make sure the roll of
paper turns freely. If it does not turn freely, the paper will jam and can possibly damage the
printer mechanism.
1. sing the Paper Feed Switch, advance U
2. Lift the paper roll away from the printer housing and cut the paper feeding to the printer with
scissors. Try to make the cut as square as possible to help the next time you reload the
paper.
3. Pull the remaining paper through the printer mechanism. Be sure to pull the paper from t
top (paper cutter side).
RNING: Pulling the pape A
mechanism.
PERATIN O
The Paper Feed switch on the printer i
to toggle the printer ON or OFF. A red light will go on when the printer switch is ON. Push the
right side of the switch to advance the paper.
AINTENANCE M
hen printing become W
cartridge ribbon.
If your printer is used infrequently, the print impression may become weak because the ribbon
dried out. In that case, advance the ribbon to a new section by holding down the Paper Feed
switch for several seconds.
R