Castle TSM-12 - Manual (Page 21)

CASTLE, INC TSM‐12 OWNERS MANUAL V1.0 Page 21 of 23
4. To install your drill motor it should be rotated so that the vertical feature on the motor
cowling is in contact with the Motor Stop Tab on the small motor carriage. (Fig 35). Align
the drill motor with the small motor carriage as shown. (Fig 36) You DO NOT want a gap
between the tab on the motor carriage and the drill motor cowling. (Fig 37).
Note: Failure to properly align the drill motor in the small motor carriage may result
in pilot holes that are off-center.
5. Tighten the hose clamp with a slotted screw
driver (Fig 38).
Correct Incorrect
Fig 37
Fig 35
Motor Stop
Tab
Fig 38
Fig 36