Castle TSM-12 - Manual (Page 14)

5. Push the black handle away from operator rapidly until
it hits the stop (Fig 20). This routs the pocket. If you
release the black handle, the machine will move to the
neutral position on its own. It is not necessary to
release the black knob before proceeding to step 6.
Fig 20
Note: The first pocket you cut will create a through slot in the worktop. To insure a
clean cut, make sure a work piece is securely clamped in place.
6. Pull black handle toward you rapidly until it hits the
stop (Fig 21). This drills the pilot hole.
CASTLE, INC TSM‐12 OWNERS MANUAL V1.0 Page 14 of 23
7. Release the black handle. The operating lever
returns to the neutral position by itself.
Fig 21
8. Pull the clamp lever (red handle) toward you to release
the material clamp (Fig 22).
9. For additional pockets repeat steps 2 through 8.
Fig 23
Fig 22
Note: For optimal performance it is recommended that your cycle time be as quick
as possible. A slow cycle will result in your tooling dwelling in the material and contribute
to shortened tool life.