Castle TSM-12 - Manual (Page 20)

4. Re-install the router in the yellow carriage, carefully
noting the orientation depicted below. With the
motor firmly engaged against the carriage, tighten
the locknuts with a 7/16” wrench and the bar knob
alternating between both to ensure even tension on
the U-bolt (Fig 32).
Fig 32
6.2 Pilot Bit Replacement
1. Unplug the TSM-12 from the electrical outlet.
CASTLE, INC TSM‐12 OWNERS MANUAL V1.0 Page 20 of 23
2. Loosen the hose clamp with a slotted screw driver
(Fig 33), and pull the drill out of the machine.
Fig 33
3. Remove the dull bit using the wrench provided (Fig 34). It may be necessary to lightly
tap the collet to loosen the bit. Insert the replacement drill bit until the tapered portion of
the shank is approximately flush with the collet opening. Secure the bit.
Fig 34