Kaiser С фронтальной загрузкой - Manual (Page 8)

8
EN
1
3
2
Caution! Connection of hoses and cords as well
as placing the appliance into operation must be
made by a qualified expert only. Incorrect
installation may result in damage to persons and
property.
CONNECTING TO WATER SUPPLY AND
SEWERAGE NETWORK
Connecting the Aqua-Stop inlet hose
The inlet hose equipped with Aqua-Stop System 1 is
provided with double walls. The Aqua-Stop System
ensures blocking of water supply in case the inlet hose
has broken as well as if the air gap between the hose
itself and its corrugated shell is filled with water.
Connect the appliance to the water mains with new
hose sets only. Never reuse old hose sets.
Water pressure must amount to 0,05 MPa (min.) and 1
MPa (max.). In case the pressure is below the minimum
value, consult the Service Center.
• Pull the inlet hose completely out from storage
compartment located at the back of the
dishwasher.
• Connect the corner end of the inlet hose 2 to the
machine.
• While adjusting to the faucet, tighten the screw 3
of the safety inlet hose (3/4-inch thread).
• Before starting the washing machine, turn on the
faucet against the stop.
Connecting cold water
Connect the cold water inlet hose to the threaded 3/4-
inch connector. Make sure it is fastened tightly.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure
that the water is clear and free of impurities.
If this precaution is not taken, there is a risk that the
water inlet can get blocked and damage the appliance.