Burke Flooring EcoFitness Interlocking Tile Installation - Manual

Specification Data
-- RESILIENT ATHLETIC FLOORING 09 65 66
Burke Flooring Products, a Division of Burke Industries
2250 South Tenth Street, San Jose CA 95112
(408) 297-3500 E: Burkeflooring.com
INSTALLATION Instructions
EcoFitness Interlocking Tile
INTRODUCTORY NOTE: This installation guide is intended to provide the necessary information
for the proper installation of EcoFitness Interlocking Tile. These instructions are believed to be based
on accepted industry standards and are provided for informational use only. BURKE
FLOORING.DOES NOT WARRANT ANY INSTALLATION PERFORMED PURSUANT TO
THESE INSTRUCTIONS OR OTHERWISE AND SPECIFICALLY DISCLAIMS LIABILITY
FOR ANY DIRECT OR INDIRECT PERSONAL INJURY, PROPERTY DAMAGE OR OTHER
COSTS OR LOSSES RESULTING FROM INSTALLATION. Burke Flooring Products should be
installed by qualified and experienced personnel.
1
VERIFY packing slip matches with product and order.
2
INSPECT delivered product thoroughly. Report any discrepancies of original order, product
defects, etc. No reimbursement/warranty claim will be given for labor on material installed with
visual defects. Any defects – size, color, or otherwise – must be reported to the place of purchase
prior to installation.
3
STORE product and adhesives in clean, dry, environment with temperatures between 70° and
95° F. (21° -35°C).
4
READ these installation instructions, warranty and other disclaimers carefully and completely
before beginning any installations.
Warning: DO NOT use recycled rubber products in conjunction with any petroleum based products.
This includes solvents, adhesives or sealants. All substrates (especially new concrete) must be fully
cured for 45 to 60 days prior to installing rubber products.
PREPARATION
EcoFitness Interlocking Tile must reach ambient room temperature to ensure a secure, tight
installation with minimal size fluctuation. Each piece should be allowed to set for a full 24 hours
prior to beginning installation. This allows the product to size-stabilize at the typical room
temperature. Inspect the product prior to installation for measurable defects or variations.