Neff C77V60N2 - Manual (Page 52)

Neff C77V60N2 | 03/2011
52 | English
Place container under milk frother

Y
Place a container with a capacity of 0.5
litres under the milk frother (19).
Press
z
(6).
If the water filter is activated, the
following message is displayed:
Remove filter 
Y
Remove the water filter and press
z
(6).
Add 0.5 l water and descaler 
Y
Pour lukewarm water into the empty
water tank (8) up to the “0.5 l” mark and
dissolve two descaling tablets in it. Press
z
(6). The descaling programme now
runs for about 20 minutes:
Descaling
If there is not enough descaling
fluid in the water tank, the fol-
lowing message is displayed:
Not enough descaling fluid
Refill fluid
Pour lukewarm water into the empty water
tank (8) up to the “0.5 l” mark and dissolve
two descaling tablets in it. Press
z
(6).
The descaling programme will continue.
Clean and refill water tank 
Y
Rinse the water tank and refill it with fresh
water up to the “max” mark.
Press
z
(6). The descaling programme
will now run for about 1 minute:
Descaling
Empty drip tray
Empty the drip tray (18).
Replace drip tray
Replace the drip tray.
Replace the filter if one is being used.
The appliance is ready for use again.
Cleaning
If the prompt Service - clean is displayed,
press and hold down i (1) for at least three
seconds. The display shows:
Clean  Press
Y
or
To start without the prompt (see „Displaying
Settings”) press and hold down i (1) for at
least three seconds and select
Clean  Press
Y
Press
z
(6). The display will guide you
through the programme.
Empty drip tray
Empty the drip tray (18).
Replace drip tray
Replace the drip tray.
Cleaning
Open drawer
Deploy the appliance and open the
drawer (10).
Insert cleaning tablet! Close drawer!
Drop a cleaning tablet in the drawer and
close the drawer again.
Press
Y
Press
z
(6). The cleaning programme will
now run for about 7 minutes:
Cleaning
Empty drip tray
Empty the drip tray (18).
Replace drip tray
Replace the drip tray.
The appliance is ready for use again.