Neff C77V60N2 - Manual (Page 44)

Neff C77V60N2 | 03/2011
44 | English
Preparing milk froth and warm
milk
Risk of burns!
The milk frother (19) gets very hot.
After use, allow to cool down first
before touching.
For optimal milk froth, use cold milk
with a fat content of at least 1.5 % if
possible.
1. Take the milk tube (12) and connect it to
the milk frother (19)
(see “Preparation using milk”).
2. Place a cup or glass under the outlet of
the milk frother.
3. Select the required setting for Milk froth
or Warm milk with the navigation button
(4):
My coffee Milk froth Warm milk
4. Press
z
(6); milk froth or warm milk
runs out of the milk frother outlet (takes
about 40 or 60 seconds respectively).
Press
z
(6) again to cut the process short.
The appliance may make a whis-
tling noise when warm milk is being
prepared. This is caused by the milk
frother (19) for technical reasons
Dried milk residue is difficult to re-
move, so clean the milk frother im-
mediately after use
(see “Cleaning the milk system”).
Dispensing hot water
Risk of burns!
The milk frother (19), from which
the hot water flows, gets very hot.
After use, allow to cool down first before
touching.
The appliance can also be used to dispense
hot water, e.g. for tea.
1. Place a cup or glass under the coffee
outlet.
2. Select Hot water with the navigation
button (4):
Warm milk Hot water Short rinse
∼ 85ºC
3. Press
Z
(5) to switch to the temperature
selection. Set the required temperature
with the navigation button (4):
Hot water
∼ 80ºC ∼ 85ºC ∼ 90ºC
4. Press
z
(6); hot water runs out of the
milk frother outlet for about 40 seconds.
Press
z
(6) again to cut the process short.
Warm up cups before use,
especially small, thick espresso
cups, with the hot water.